 No.17604
Tafoid Administrator
May 3, 2020, 23:16
|
Again, I'm suspect that these 'oversensitive' issues are actually emulation issues. It is obvious that the intent was to allow entering credits quickly by holding down - it could simply be you inputs are repeating too quickly? Try adjusting your keyboard controls for your OS and see if you can lengthen the repeat delay and/or repeat rate. |
|---|---|
 No.17607
joepublic Tester
May 3, 2020, 23:56
|
Thank you. I tried adjusting the repeat delay to 1000ms, and disabling key repeat altogether, but in both cases still observe the same behavior with the Bet repeating instantly in xtrain/mtrain/victor6. |
 No.17623
mdqgames Tester
May 9, 2020, 03:08
edited on: May 9, 2020, 03:09
|
The XTAL values seem to be very high for some subsino games, in the "humlan" game for example the XTAL is at (48'000'000) / 3) and moving to (12'000'000) / 3) All speed is correct, including the speed of the internal game configuration. |
 No.17624
Osso Moderator
May 9, 2020, 05:23
|
"The PCB is similar to bishjan and new2001, but with a 48MHz crystal and a 9804 (instead of 9904) for sound." So the 48MHz XTAL is right. Maybe the divider is higher, but without measuring the clock on PCB it's difficult to see. |