Viewing Issue Advanced Details
ID Category [?] Severity [?] Reproducibility Date Submitted Last Update
07638 DIP/Input Minor Always May 1, 2020, 13:03 May 10, 2020, 12:02
Tester joepublic View Status Public Platform Other
Assigned To Resolution Open OS Linux (64-bit)
Status [?] Acknowledged Driver subsino2.cpp
Version 0.220 Fixed in Version Build 64-bit
Summary 07638: xtrain, mtrain, ptrain: [possible] Oversensitive Bet key repeats immediately
Description Bet key repeats immediately, making input difficult
Steps To Reproduce Add credits, then press and briefly hold Bet. Easiest to observe if Min. Bet. is set to 1 in F2 service menu.
Additional Information
Flags Possible
Regression Version
Affected Sets / Systems xtrain, mtrain, ptrain
Attached Files
 
Relationships
There are no relationship linked to this issue.
Notes
4
User avatar
No.17604
Tafoid
Administrator
May 3, 2020, 23:16
Again, I'm suspect that these 'oversensitive' issues are actually emulation issues. It is obvious that the intent was to allow entering credits quickly by holding down - it could simply be you inputs are repeating too quickly? Try adjusting your keyboard controls for your OS and see if you can lengthen the repeat delay and/or repeat rate.
User avatar
No.17607
joepublic
Tester
May 3, 2020, 23:56
Thank you. I tried adjusting the repeat delay to 1000ms, and disabling key repeat altogether, but in both cases still observe the same behavior with the Bet repeating instantly in xtrain/mtrain/victor6.
User avatar
No.17623
mdqgames
Tester
May 9, 2020, 03:08
edited on: May 9, 2020, 03:09
The XTAL values seem to be very high for some subsino games, in the "humlan" game for example the XTAL is at (48'000'000) / 3) and moving to
  (12'000'000) / 3) All speed is correct, including the speed of the internal game configuration.
User avatar
No.17624
Osso
Developer
May 9, 2020, 05:23
"The PCB is similar to bishjan and new2001, but with a 48MHz crystal
and a 9804 (instead of 9904) for sound."

So the 48MHz XTAL is right. Maybe the divider is higher, but without measuring the clock on PCB it's difficult to see.